I am looking for a front ski spindle , windshield, and a carb boot ( carb to manifold). I would also like replacement hood hold downs and the passanger handles for the rear. This sled is a 1977 kawasaki sno-jet 340 sst. This year has the yamaha motor in it. Any help with used or NOS parts would be awsome . Thanks to all who look.
WTB Carb boot and spindle '77 Kaw 340SST
Join the discussion
Recommended Reading
-
Replacing throttle cable on a 1981 panther 4000
Vintage SnowmobilesNever done it before is it hard? Any tips? I ordered a cable from Parts Reloaded... the old one is still functioning, but is frayed badly with just a small strand holding it. My main concern is the rubber handle bar padding... how does that come off? Any suggestions are welcome!- 0
- 52
-
1992 excited 2 570
Vintage SnowmobilesGuys pls help. Carbs are cleaned twice over coils have been swapped compression is 120 per side checked for bad crank seals. Still Boggs at 3000rpm at full throttle. But if I let it die down to idle and ease into it and go full throttle it revs up- 3
- 65
-
1990 Polaris 650 Triple-- HOOD??
Vintage SnowmobilesAnyone know wat years hood n windshield n lights are compatible with my 1990 Polaris Indy 650 Triple?- 3
- 66
-
ArcticCatDad · updated
-
1978 John Deere Spitfire
Vintage SnowmobilesHi All! I just picked up a 1978 John Deere Spitfire for $250. The seller claimed it runs, but cold start is rough. When I went to pick it up, we couldn't get it to start. The ceramic material in spark plug caps is broken and electric tape was wrapped around it so the cap would stay on the plug...- 12
- 222
-
Help
Vintage SnowmobilesHave 1980 artic cat panther rebuilt fuel diaphragm pump last winter and had to fill fuel lines every time to get it going. this year filled up lines with fuel and it will run till that fuel is used up but will not pull anymore out of tank. Replaced all fuel lines and vacuum line. Put finger over...- 2
- 83
Join now to ask and comment!