Snowmobile Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
hi my vmax was running nicely and i left it idleing because i was having trouble keeping a steady idle, when i went to ride it back into the garage to put it away it will rev to around 2500 and then backfire, but wont move? can anyone give me any tips?
thanks
 

·
Registered
Joined
·
2 Posts
its your tors ..check your throttle cable for slack ..if their is no slack .give it some .(vary little ) or their is to wires that run vary close to the center carb unplug them and plug them into each other to by pass
also carb clean may be needed
 

·
Registered
Joined
·
318 Posts
I doubt he is around. This post is over 11 years old!
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top