hey guys,
When i began to torque the bolts on my crankcase after sealing them with liquid gasket, my torque wrench did not click when it was suppose to and i ended up tightening the first bolt too tight and had to back it off. I re-tightened them to the specified torque but i am now concerned that it may leak because of that.
Should i separate the halves and re-do the whole process?
All input welcome
thanks
When i began to torque the bolts on my crankcase after sealing them with liquid gasket, my torque wrench did not click when it was suppose to and i ended up tightening the first bolt too tight and had to back it off. I re-tightened them to the specified torque but i am now concerned that it may leak because of that.
Should i separate the halves and re-do the whole process?
All input welcome
thanks