Snowmobile Forum banner
1 - 1 of 1 Posts

98 Posts
Discussion Starter · #1 ·
Just put a new Ultimate-3 belt on '96 Storm. Secondary clutch cam is set to #1 position and primary clutch bolt came out 3 times while riding.
1) What is the torque spec on primary clutch bolt.
2) How do you know where to set the cam in secondary ? 1-5 setting 5 opens up and 1 is closed. It was on 5 and I was smoking belts. 1 may be to tight but belt is not protruding 1/8" over the clutch like I think it should ?
thanks in advance................
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.