hi, i have recently bought a '96, 680 ultra sp with psi pipes, and its ported and polished, and i just wanted to know what size jets i should be using if im running at 2300 ft above sea level. also if there are any jetting charts on the net. any imput would be very greatly apreciated.
Jetting
Join the discussion
Recommended Reading
-
Parts breakdown
Polaris SnowmobilesI see service manuals, but i need a parts breakdown for rear suspension 92 indy 500 efi.- 19
- 219
-
Under hood foam
Polaris SnowmobilesA bit new at this, how importsnt is the foam under the hood? If it is important whrre do I get some?- 3
- 56
-
Let’s Get These Skis Off!
Polaris SnowmobilesHey guys, I bought some used plastic skis for my 1998 Polaris Indy 500 and I want to put them on for the obvious benefits. I go to try to take the bolt holding the ski on and I get the codder pin and nut off but the bold won’t come off —darn— how do I get his off. I’ve tried hammering it the end...- 7
- 78
-
thatclassicsledfan · updated
-
Help Identifying xtra-10 suspension
Polaris SnowmobilesI am going shopping in the morning for used parts, (found a guy on craigslist) either to buy service parts or a replacement unit. Both are in budget. How can I identify if a replacement unit will work in my '92 indy 500 SP 500 using the same track, minor mods stuff is OK, but don't want to dive...- 4
- 113
-
XX suspension
Polaris Snowmobiles1992 indy 500 sp efi I have the rear suspension stuff out, and as detected in another thread, it has issues. I found all of the wheel bearings bad. The bar i have been asking about was in fact a shock absorber. Here are my current issues, are the bearings available in bulk? Having a problem...- 6
- 119
Join now to ask and comment!