Snowmobile Forum banner

How do I source out the bottom gap for my particular slides?

630 views 4 replies 3 participants last post by  kccats 
#1 ·
I've been going through many write ups on this site for dealing with carbs, and I have to say thank you to all those members, here and gone, who wrote them - they are really well done. So, thanks.

I do have a plan on how to 'sync' them by feel, which I am going to try as mine look quite off, but how do I know what height I should set them at to begin? I figure I'll get that size drill bit and begin there, but since mine are sitting at two different settings, I want to begin at the proper level.

TIA

And, for the record I haven't begun to clean these yet. :)
Gas Motor vehicle Machine Auto part Metal
Motor vehicle Camera lens Reflex camera Wood Cameras & optics
 
See less See more
2
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top