Snowmobile Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
172 Posts
Discussion Starter · #3 ·
Thanks yamadad,

I replaced the coil w/ a new spare I had but made no change. I did notice that the headlight harness dropped down and melted on the exhaust exposing some wire. Could that have fried something? I unplugged it before the melted spot and it made no difference. Any idea what may be causing the weak/no spark?
 

·
Registered
Joined
·
172 Posts
Discussion Starter · #6 ·
It is the single coil w/ two plug wires. Has a single wire that plugs into the harness and a ground wire from harness to coil.

The replacement coil is new.

Any suggestions on where to go from here? Check for bad ground??
 

·
Registered
Joined
·
172 Posts
Discussion Starter · #8 ·
Had to transfer caps. I replaced the caps about a week ago on the old coil though. The hole on the cap where the wire goes in is actually larger than the wire making it hard to center the spur into the wire. I'll get the correct size caps tomorrow and see if thats it.

Thanks for the help, my moneys on the caps now.

I'm getting pretty good at keeping these old girls (4 old Enticers) running but electric problems/issues shut me down.LOL
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top