Snowmobile Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I LOVE TRIPLES
I LOVE the power, the pull, and most of all the top end mph!!!
I have a 97 Mach which I have been very pleased with until this past season. I have lost the mid range snap or pull. I very frustrated because people have mentioned clutch alignment, dirty or clogged raves...or worst of the omen of the 700 triple,,,, bearing failure on the PTO side of the Crank Should I have it vacum checked to see if air is sneaking by.. Any Ideas or suggestions??? Please Help..... Is there a true fix for this??? I heard some people bring the motor to get some hole milled so there is better oil penetraion.. Ride Safely and Pray for snow!!!
thanks, TIZ700:(
 

·
Registered
Joined
·
26 Posts
Yes have the engine pressure tested. These were known for bearing failures. Ski-doo has a procedure to fix this from happening again. Check your piston skirts for scuffing.
 
1 - 2 of 2 Posts
Top