[Scootertrash]

Need some help tracking this down. kill switch tests out OK (continuity when in the off/down position, no continuity when up/on. TORS seems to be working properly ( if I hold the pivot pin in place and then press the throttle I get continuity. Press on throttle without holding pivot pin in place no continuity. A schematic and/or some specs woud be great.

Thanks guys!!
Scooter

 

[RJ Gleason]

Bypass TORS.
Unplug from carbs and connect harness ends together.

 

[Scootertrash]

Harness ends meaning the ones from the throttle or the ones at the carbs?

 

[RJ Gleason]

At the carbs.

 

[Scootertrash]

Just wanted to update this thread with the results of my troubleshooting of this issue:
Turns out the contacts on the TORS switch at the carbs were dirty/not making good contact. Before investing a new part, I removed the switch and carefully took it apart. Nothing was broken or missing so I lightly sandpapered the contact points on the switch, cleaned it, put it back together and then bench tested it, I had continuity, so I put it back in the sled and it fired right up.

Hope this helps someone with the same problem.