Snowmobile Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I've taken the three speed gearbox out of my 2001 Skandic WT LC 600. Rebuilt it and am trying to put the driven pulley back on the input shaft. It seems to be an interference fit,. Do I have to heat the crap out of the pulley to get it on the shaft? It came off easy without to much trouble. Any advice would be helpful.
I do not recommend rebuilding these gearboxes If you have a transmission shop nearby seriously consider letting them do it. IT WAS NOT FUN!! Ski-doo did not make it maintenance friendly and parts were stupid expensive.
 
1 - 1 of 1 Posts
Top