Snowmobile Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter · #1 ·
ok so by buddy has a 2000 mach and he droped the rear part of his skid frome 1 inch so the back end of the sled sits higher...i just did this to my 01 mach (different skids) so i drilled a new hole 1" lower on the drop down bracket, and now it sits higher and looks great but the skid bottoms out when you push it down like 2 inches....not sure why there is like a pivot point at the bottom near the rails at the back and its like a coupler that limits the travel and its bottoming out now... is there any adjustment with this? any one do this?

thanks
connor
 
1 - 1 of 1 Posts
Top