Snowmobile Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Ski-Doo Snowmobiles
    Hi everyone, Looking at a 2013 MXZ 600 tnt H.O with 6000 miles on it. Sled looks very clean only one owner. Newly serviced and a studded track. I’m wondering what there is to look out for on these sleds and what a fair price for it would be? Thanks
  2. New Members Forum
    Hi my sled runs and the electrical just doesn’t work and also the reserve button doesn’t work, I was thinking it is the voltage regulator but I can’t seem to locate it. Any feed back will be helpful
  3. Ski-Doo Snowmobiles
    Hey everyone. I have a 2006 rev with a 2002 700 motor. I rebuilt the top end and it ran. I did a few heat cycles went for a 10 minute ride and parked it. Went go for a ride the next day and it wont start. I changed the plugs. I put gas down the heads too and still nothing. I checked spark with...
  4. Ski-Doo Snowmobiles
    I recently purchased a 2010 MXZ 800r Ptek. After starting it, it runs great for about 30 seconds to 1 minute. Then once idle for that time, it the cylinder opposite of mag side drops and the sled idles on one cylinder until you throttle it again. Once it drops to one cylinder, the gauge cluster...
  5. General Sled Chat
    Hi I have a 2000 mxz 700 and it keeps dropping a cylinder, when I clean the carbs it stays on 2 cylinders for 10 minutes and then drops back down to 1. I clean the carbs then switch them around so the one that drop the cylinder is on the right side, it only drops a cylinder with one carb if I...
  6. General Sled Chat
    Just got a 1998 mxz Rotax rave ran fine for few minutes then hit brake and the caliper locked up and won’t release. Should I replace cailiper or try taking it apart and cleaning it. If you think I should replace it where would you suggest to buy new caliper. Thanks in advance.
1-6 of 6 Results
Top