Snowmobile Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Engine / Drivetrain
    I have a 1997 Indy Trail where the cylinder has some scratches in it. Can it be honed or ru. It like it is?
  2. Ski-Doo Snowmobiles
    I recently purchased a 2010 MXZ 800r Ptek. After starting it, it runs great for about 30 seconds to 1 minute. Then once idle for that time, it the cylinder opposite of mag side drops and the sled idles on one cylinder until you throttle it again. Once it drops to one cylinder, the gauge cluster...
  3. General Sled Chat
    Hi I have a 2000 mxz 700 and it keeps dropping a cylinder, when I clean the carbs it stays on 2 cylinders for 10 minutes and then drops back down to 1. I clean the carbs then switch them around so the one that drop the cylinder is on the right side, it only drops a cylinder with one carb if I...
  4. Polaris Snowmobiles
    Starting a new thread after my low compression issue threads started getting long and off track. So diagnosing my inability to hold idle and poor power, I replaced my fuel pump, ran a new line to the pulse inlet, completely and meticulously cleaned my carbs, checked my clutching, and got it...
  5. Arctic Cat Snowmobiles
    Hey all, I'm having a real quirky problem with my Jag (actually a 81 4400 but it dropped a piston skirt and blew out the crank case, so replaced it with a 78 340cc motor). The motor has one Mikuni carb, that feeds two cylinders. But the cylinder on the left ("driver side") is running hot and...
1-5 of 5 Results
Top