1991 Yamaha Phazer II Extra Wires? - Snowmobile Forum: Your #1 Snowmobile Forum

JoeFromBoston · 12-20-2007, 03:43 PM

Hello. I finally picked up a pair of heated grips (hotgrips) and have them glued on. Now for the wiring. I started looking for somewhere to get power from. Before I opened it up I was just going to slice into the headlight wiring. But after I opened things up I noticed a set of wires that don't go anywhere. Can I use these?

Again this is a 1991 Yamaha Phazer II. It is a basic sled without electric start etc. Thanks!

Jaded · 12-20-2007, 05:05 PM

I'm not the best with electrical but if it were me I would hook up to the wires and test it out. If there's an in-line fuse and you're doin something you shouldn't be, the fuse should blow. Chances are that's what those wires are for.

FxsX24 · 12-20-2007, 07:09 PM

is one a male and one a female connector coming out near the steering shaft?
try those, if they dont work then splice into the lighting coil
i think the wires mentioned above are for acc coil #2 which you may or may not have

**smallengineguy** · 12-20-2007, 07:29 PM

DON'T splice into the light wires! It'll dim the hell out of your headlight! Tap into the hot lead going to the key switch.

JoeFromBoston · 12-21-2007, 01:49 PM

Well I ended up soldering on to the extra wires and so far so good. Drove about 20 miles last night and they heated right up. Thanks for all your comments.

I still can't believe we have over 2 feet of snow in Massachusetts IN DECEMBER. Crazy.

Merry xmas all!