ben.simons

94' 650 efi to carb swap? Is it possible? New to the sled world, but know my 4-strokes.. is this even possible? And if so, easy and cheap?

Sent from my DROID4 using Snowmobile.com App

RJ Gleason

You will need the following;
Fuel pump
Carbs
Stator
Wiring Harness
You may have to drill a hole for the pulse line barb

__________________
Old Cat Rider
'93 Wildcat 700EFI
w/ Comet 108 Pro-4 clutch & 01 ZR skid

'90 Wildcat Project in progress.

Vintage (sorta)
1980 Indy Trail 440 (for sale)
1980 AC Pantera (donor engine to the 90 wildcat)


http://www.dcdrifters.net/


Senior Warden; F&AM Dryden Lodge# 472
http://www.masonicdryden472.org/

Rules of this forum are strictly enforced!

ben.simons

Ok thank you, i checked ebay and i found 650 triple carb setup from a jetski?? Any chance that would fit? All on the intake manifold, and also found 3 single carbs from an indy 650 classic. And also where would the wire harness be tied into?

Sent from my DROID4 using Snowmobile.com App

white lightning

I wouldnt go with that - look around and youll find a non running 650 SNOWMOBILE with a complete setup youre looking for .. cheap. WL

RJ Gleason

Pwc motors are set up differently from sled motors.
You would have to swap in the entire motor for it to work.

__________________
Old Cat Rider
'93 Wildcat 700EFI
w/ Comet 108 Pro-4 clutch & 01 ZR skid

'90 Wildcat Project in progress.

Vintage (sorta)
1980 Indy Trail 440 (for sale)
1980 AC Pantera (donor engine to the 90 wildcat)


http://www.dcdrifters.net/


Senior Warden; F&AM Dryden Lodge# 472
http://www.masonicdryden472.org/

Rules of this forum are strictly enforced!