Hi, I just bought a 99 polaris xcsp 700 and I have to get the seat repaired. The seam right at the very back where the seat part meets the backrest let go and I need to know how to remove the seat. Any help/ diagrams would be helpfull! thanks!
Look for two bolts that hold the rear of the seat on. You should be able to access one end from in the tunnel and the other end from inside the storage compartment. With those two bolts gone, pull the seat back, it should undo from clips on each side of the gas tank.
2007 Dragon RMK 700 155", 2008 RMK 600 155", 95 Prowler 550 2-up, Really OLD AC Cheetah
Also, don't pull up on the back of the seat too much. Yanking it upwards will bend/break the clips or the seat base. You can lift it a couple inches, but don't just yank up on it. Sliding it back will release it from the front clips.
Also, if it has the big wrap around taillight those two bolts holding it down are behind the big center rectangular section. Its not actually a light in the center on mine its a big reflector and the sides do the lighting. But you dont even need to get in there as they are threaded in from the bottom into a nut welded to the taillight/seat frame. poke your head underneath and locate the two bolts about 5" apart very near the end of the tunnel. Thats them.
1998 Polaris XC600 (with a XCR sleeper hood on it)
2006 Polaris Indy 500
1969 Chevy C10 "69CRUZR"
-383 stroker 450 hp 479 ft lbs of torque
2006 Chevy Colorado -daily driver
New Project Truck, this one for my Pops!
1953 GMC 5 Window Shortbox Stepside
Drivetrain: 2006 5.3 Liter v8 with 4l60e from an 06 Silverado.
Full IFS front suspension kit w/rack and pinion steering, and 4 link rear from TCI Enterprises.