Snowmobile Forum banner

503 fan !!!!! HELPP!!!!!!

2K views 16 replies 8 participants last post by  Rczr600rider 
#1 · (Edited by Moderator)
Ok so i have a 1997 skidoo mxz 440 fan with a 503 transplant. whoever did the the transplant did a pretty poor job with all the wiring and everything. when i got the sled the motor was leaking oil out of the PTO crank seal. once i tryed to replace that all i found was problems. all of the bearings in the lower end were gone. ( i think she was run dry of oil one to many times).. but anyways... i had the motor rebuilt and i installed it, took it on a 60 mile ride and it ran fine.. i got home and the lights dont work.. but they did on the ride.. i have no head light, no dash light, no tach, and no speedo... anyone have any ideas?
 
#14 ·
Lighting coil? You'll need an ohm meter to check the resistance. Not sure the specs or which two wires to hook up to, someone will know........
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top