Throttle, omg - Snowmobile Forum: Your #1 Snowmobile Forum

fbmbmx1211 · 02-04-2007, 01:18 AM

This sled is a pile, I love it but I got the thing working and now this ok the calbe splits into two in the middle and there is this litttle canister type thing where all the calbes come together, liek a bmx gyro. Anyway, that canister broke and I tryed ghetto riggin' it together and all but no. so I need to know if i can buy that middle thing, what its called and if not how do i remove the cable from the inside of the carb cause i cant figure that out either You should see the snow coming down right now

mmrosshere · 02-04-2007, 02:10 AM

Ok Mello. no need for the big hammer to come out. If you take off the top of the carbs it will be obvious I think you have mic. carbs on that you un screw the top and with the cable will come the slide and the pin as well as a spring. you should see where the cable ball end slips in to a key way. You have gotten this far I am sure you can do this.

mmSeven · 02-04-2007, 02:20 AM

I think you are talking about the throttle cable junction block (the thing where the 1 throttle cable splits into multiple cables that go to each carb and the oiler). I don't think you can replace just the block, you probably have to buy the whole cable assembly. You might be able to find one used on eBay or something... what kind of sled is it?

**smallengineguy** · 02-04-2007, 07:41 AM

You have to find a new cable, you can't replace just the block.