xcpolaris

I have a 1983 yamaha enticer that i would like to put a different suspensinon in, i know rite now that the track on there is a 15" x 108" and i would like to go up to a 15" x 121", i have an M10 suspension laying around in the shop along with a rear suspension out of a yamaha Phazer, Im wondering how difficult it will be to fit either one of them in there and how to go about mounting it, any help would be greatly appreciated

RJ Gleason

You will need to swap out the drive shaft as the track drive ratio is different.
Measure the mount holes on the donor tunnel and then you should be good to go.

__________________
Old Cat Rider
'93 Wildcat 700EFI
w/ Comet 108 Pro-4 clutch & 01 ZR skid

'90 Wildcat Project in progress.

Vintage (sorta)
1980 Indy Trail 440 (for sale)
1980 AC Pantera (donor engine to the 90 wildcat)


http://www.dcdrifters.net/


Senior Warden; F&AM Dryden Lodge# 472
http://www.masonicdryden472.org/

Rules of this forum are strictly enforced!

kccats

Basically You will need to swap out the drive shaft as well as the suspension and track from the Phazer!

Yamaha440

When you swap out the drive shaft, you may have to re gear the chaincase.

__________________
My Current Sled:
1997 Yamaha Vmax XTC 600 Twin ER 6290 MI - Stock... for now...

Old Iron:
1979 Yamaha Exciter 440 6042 MI (9825 KM)
1979 Yamaha Exciter 440 7,000 MI (11266 KM)

WAKE-UP AND SMELL THE TWO STROKE

yamadad4

swap the driveshaft? or just change the drivers on the track? i just changed drivers when i did mine.

due to the design differences between an enticer driveshaft vs a phazer driveshaft, i would question the compatability, unless you guys know different.

kccats

I still havent gotten to that Bravo to see yet!