how many should i have. please help!!! - Snowmobile Forum: Your #1 Snowmobile Forum

prowler special · 07-30-2008, 10:49 AM

oki bought a bearing for the chaincase side of the driveshaft not the input shaft. and i have the speedo side hooked up already and i see that i have 4 flange plates that hold the bearing in and i only see room for three. did my otherone just happen to end up on hte garage floor next to it somehow or does it have a rightful spot?

please please please help me! any pictures would also be very nice thank you much!!

**RJ Gleason** · 07-30-2008, 12:47 PM

The 4th one might still be inside the chain case.
Although, I don't remember there being 4 as the chain case end bearing fits into the casting.

prowler special · 07-30-2008, 01:53 PM

ok there is supposed to be three i was just panicking because i had a fourth one and i didnt know where it came from but it came from my snowblower(long story)

But thanks RJ much appreciated!